Liten Engineering Products Pvt Ltd : Manufacturer of Liten Liquid Meter

» Selection of Meters

Select meters according to Rate of Flow, not pipe size. Flow ranges represent safe operating rates for maximum accuracy (+- 1%) and life with moderate pressure loss. Flow ranges. Based on viscosity are approximations only. Use of strainer with each meter is a must.

METERING RANGE (Litres/hr)
Model N.B.	Non Corrosive oils & fuel oils Viscosity in CPS					Hot & Cold water	Corrosive Liquids
	Below 1.5	1.5-5	5-15	Hot F.O. 15 to 50	Cold F.O. above 50
100 LL ½”- 12 mm	30-50	12-30	10-30	5-25	2-20	30-50
100 L ½”- 12 mm	50-150	30-100	30-120	20-100	15-75	50-150	50-150
100 ½”- 12 mm	150 to 1000	100 to 1000	100 to 1000	50 to 300	20 to 200	150-1000	150-1000
150 ¾”- 18 mm	250 to 1000	150 to 1500	150 to 1500	75 to 400	50 to 300	250 to 1500	250 to 1500
200 1”- 25 mm	400 to 4000	400 to 5000	500 to 5000	200 to 2000	75 to 500	400-4000	400-4000
250 1½”- 37mm	600 to 6000	600 to 6000	700 to 7000	700 to 7000	200 to 4000	600 to 6000	600 to 6000
300 LL 2”- 50mm	1000 to 9000	1000 to 9000	1000 to 100000	1000 to 10000	500 to 9000	1000-9000	1000-9000
400 3”- 75 mm	5,000 to 20000	5000 to 25000	8000 to 30000	8000 to 40000	5000 to 20000	5000-20000	5000-20000

*Continues flow capacity of the meter is about 70 % of the maximum flow rating. This only a general guide. Actual flow range can be modified for optimum use of the meter.

» Dimension & Weight


Model	100	150	200	250	300	400	500	600
L2 (mm) L1 (mm) H (mm) Wt. (kgs.)	114 177 196 6	140 240 205 7	215 280 235 12	265 338 265 24	305 385 306 45	394 520 368 80	564 635 483 130	660 775 584 275

Back